Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing DVD Player
    GM1533131Courtesy of GENERAL MOTORS CORP.
  1. Position the DVD player into the vehicle.
  2. Connect the electrical connectors to the DVD player.
  3. Push the DVD player upward engaging the clips in order to secure the DVD player to the vehicle.
  4. NOTE: Refer to Fastener Notice .
  5. Install the screws securing the DVD player to the roof.

    Tighten:Β  Tighten the screws to 2 N.m (18 lb in).

  6. Check for proper operation of the DVD player.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.