SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 970 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)REPAIR INSTRUCTIONSMOBILE ENTERTAINMENT DATA CARTRIDGE ACCESS LOWER DOOR REPLACEMENTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Lower Door
    GM1605634Courtesy of GENERAL MOTORS CORP.
  1. Install the door to the entertainment system.
    2. NOTE: Refer to Fastener Notice .
  2. Install the door fasteners.

    Tighten:  Tighten the fasteners to 2 N.m (18 lb in).

    3. Fig 2: Removing/Installing Mobile Entertainment Assembly
    GM1617688Courtesy of GENERAL MOTORS CORP.
  3. Install the upper and lower door assembly to the lower housing
  4. Install the upper housing.
  5. Install the screws to the upper housing.
  6. Connect the door switch electrical connector to the mobile entertainment data cartridge player.
  7. Connect the electrical connectors to the mobile entertainment housing.
  8. Turn the latch assembly clockwise on both sides of the mobile entertainment housing. Latch the mobile entertainment assembly to the roof rail.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.