Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 970 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)COMPONENT LOCATORENTERTAINMENT/COMMUNICATION CONNECTORSSTEERING WHEEL CONTROL SWITCH ASSEMBLY - LEFT (UK3)

2006 Pontiac G6 GTP, 2D Coupe, Standard

Steering Wheel Control Switch Assembly - Left (UK3)

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Steering Wheel Control Switch Assembly - Left (UK3)

WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Steering Wheel Control Switch Assembly Connector End View - Left (UK3)

Courtesy of GENERAL MOTORS CORP.

Connector Part Information

OEM: 50-57-9404
Service: See Catalog
Description: 4-Way F (BK)

Terminal Part Information

Terminal: Not Serviced in Kit
Core/Insulation Crimp: N/A
Release Tool/Test Probe: N/A

Connector Terminal Identification

Pin	Wire Color	Circuit No.	Function
1	D-BU	1796	Steering Wheel Controls Signal
2	BK/WH	1451	Ground
3	GY/BK	1458	Instrument Panel Lamp Supply Voltage
4	WH/BK	644	Remote Radio Controls Supply Voltage

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.