Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 920 (ANTILOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC C0196CONDITIONS FOR SETTING THE DTC
2006 Pontiac G6 GTP, 2D Coupe, Standard
Conditions for Setting the DTC
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Conditions for Setting the DTC
WARNING: This page is about a different car, the 2007 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
C0196 00
- The vehicle speed has reached at least 15 km/h (9 mph) from a stop more three times during the same ignition cycle. During the time the vehicle is stationary, the yaw rate signal value is more than 7 deg/sec for 2 seconds.
- When vehicle speed is more than 25 km/h (16 mph) in a turn the difference between the yaw rate, steering angle, lateral acceleration, and wheel speed sensor values are not correlated three consecutive times.
- Yaw rate changes greater than 20 deg/sec in 6 ms four times in one second.
- The yaw/lateral combination sensor fails an internal self test.
C0196 28
The yaw frequency measured is not between 13400.0-14600.0 Hz for more than 200 msec.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.