Memory Seat Control Module Replacement

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Memory Seat Control Module Replacement
WARNING: This page is about a different car, the 2007 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Memory Seat Control Module
GM1574229Courtesy of GENERAL MOTORS CORP.
Memory Seat Control Module Replacement

Callout Component Name

Preliminary Procedure

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the front driver seat. Refer to Seat Replacement .
  3. Remove the front seat cushion cover and pad. Refer to Seat Cushion Trim Cover and Pad Replacement .
1 Frame, Seat Cushion
Refer to Front Seat Cushion Frame Replacement .
2 Nut, Front Seat Adjustable Memory Module (Qty: 4)
NOTE: Refer to Fastener Notice .

Tighten:Β  3 N.m (25 lb in)

3 Module, Front Seat Adjustable Memory
Tip:Β  Disconnect the electrical connector.
Refer to Control Module References for programming and setup information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.