SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 886 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)COMPONENT LOCATORENTERTAINMENT/COMMUNICATION CONNECTOR END VIEWSVEHICLE COMMUNICATION INTERFACE MODULE (VCIM) C3
2006 Pontiac G6 GTP, 2D Coupe, Standard

Vehicle Communication Interface Module (VCIM) C3

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Vehicle Communication Interface Module (VCIM) C3
WARNING: This page is about a different car, the 2007 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Vehicle Communication Interface Module (VCIM) C3 Connector End View
GM814531Courtesy of GENERAL MOTORS CORP.
Vehicle Communication Interface Module (VCIM) C3 Connector & Terminal Parts Information

Connector Part Information 
  • OEM: 917983-2
  • Service: 88988722
  • Description: 16-Way M MKII Hybrid (BK)
Terminal Part Information 
  • Pins: 2, 4, 5
  • Terminal/Tray: 175266-5/15
  • Core/Insulation Crimp: Pins 2, 4 - J/J
  • Core/Insulation Crimp: Pins 5 - K/K
  • Release Tool/Test Probe: 15315247/J-35616-16 (L-GN)
Vehicle Communication Interface Module (VCIM) C3 Terminal Identification

Pin Wire Color Circuit No. Function
1 - - Not Used
2 GY/BK 7043 Voice Recognition Audio Signal
3 - - Not Used
4 PK/BK 7044 Voice Recognition Audio Low Reference
5 BK/L-BU 813 Drain Wire
6-16 - - Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.