SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 883 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSTAIL LAMP REPLACEMENT
2006 Pontiac G6 GTP, 2D Coupe, Standard

Tail Lamp Replacement

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Tail Lamp Replacement
WARNING: This page is about a different car, the 2007 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Tail Lamp
GM1657174Courtesy of GENERAL MOTORS CORP.
Tail Lamp Replacement

Callout Component Name
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .

Preliminary Procedures

  1. Open the rear compartment lid.
  2. Remove either the LH or RH side rear compartment side trim panels. Refer to Rear Compartment Trim Panel Replacement .
1 Tail Lamp Assembly Nuts (Qty: 3)

Tighten:  6 N.m (53 lb in)


Tip:  Ensure the gaskets are on the tail lamp studs prior to re-assembly of the tail lamp assembly into the body rear end panel.
2 Tail Lamp Assembly
Tip:  Upon installation, ensure to align and seat the lower outer alignment pin and gasket to the outer body rear end panel.
3 Tail Lamp Bulb Socket
  1. Rotate both bulb sockets counterclockwise from the tail lamp assembly in order to remove the tail lamp assembly.
  2. Remove the tail lamp assembly from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.