SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 845 (DATA COMMUNICATION SYSTEM)REPAIR INSTRUCTIONSBODY CONTROL MODULE REPLACEMENT
2006 Pontiac G6 GTP, 2D Coupe, Standard

Body Control Module Replacement

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Body Control Module Replacement
WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Body Control Module
GM1602804Courtesy of GENERAL MOTORS CORP.
Body Control Module Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the left closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  2. Program the body control module after replacement. Refer to Control Module References .
1 Module Assembly, Body Control Module (BCM)
Tip:  Release the tabs on the BCM bracket and lift the module up and out.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.