SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 840 (DISC BRAKE SYSTEM)REPAIR INSTRUCTIONSDISC BRAKE BACKING PLATE REPLACEMENT - REARINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the park brake shoe and actuator (4) onto the backing plate (7).
    Fig 1: Identifying Parking Brake Components
    GM177182Courtesy of GENERAL MOTORS CORP.
  2. Position the park brake shoe, actuator (4), and backing plate (7) over the rear hub.
  3. Install the park brake cable bracket (8) and the two retainers (9).
  4. Install the rear hub. Refer to Wheel Bearing/Hub Replacement - Rear in Rear Suspension.

    The rear hub, backing plate, park brake cable bracket, and park brake actuator will be installed as an assembly.

  5. Install and connect the rear park brake cable to the bracket at the rear wheel. Refer to Park Brake Cable Replacement - Rear (Z7U) in Park Brake.
    Fig 2: View Of Rear Park Brake Cable & Wheel Speed Sensor Electrical Connector
    GM741967Courtesy of GENERAL MOTORS CORP.
  6. Connect the park brake cable return spring to the park brake actuator and bracket at the rear wheel.
  7. Install the rear rotor. Refer to Rear Brake Rotor Replacement .
  8. Install the rear caliper bracket. Refer to Rear Brake Caliper Bracket Replacement .
  9. Install the rear wheels and tires. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  10. Adjust the park brake at the equalizer. Refer to Park Brake Adjustment in Park Brake.
  11. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.