Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 834 (SECONDARY AND CONFIGURABLE CUSTOMER CONTROLS)DIAGNOSTIC INFORMATION AND PROCEDURESSTEERING WHEEL CONTROLS INOPERATIVECIRCUIT/SYSTEM VERIFICATION
2006 Pontiac G6 GTP, 2D Coupe, Standard
Circuit/System Verification
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Ignition ON, observe the BCM data display with the scan tool under Inputs-SWC Bank 1 status. Data displays SW1-SW7 identifying the switch pressed, and Idle when released.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.