HVAC Component Views

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION HVAC Component Views
WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Lf Engine Compartment
GM1653137Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor
2 Brake Booster Vacuum Sensor (LS4)
3 Windshield Wiper Motor
4 Electronic Brake Control Module (EBCM)
5 A/C Refrigerant Pressure Sensor
6 Transmission Control Module (TCM)
7 Engine Control Module (ECM)
8 G101
9 Inflatable Restraint Front End Sensor - Left
Fig 2: View Of Lower Right Front Of Engine Component
GM305309Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 A/C Compressor Clutch
2 A/C Compressor Clutch Connector
3 A/C Compressor
Fig 3: View Of Interior HVAC Components
GM1653136Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 HVAC Module
2 Mode Actuator
3 Air Temperature Actuator (C67), Air Temperature Actuator - Right (CJ3)
4 Recirculation Actuator
5 Blower Motor
6 Blower Motor Control Processor
7 Air Temperature Actuator - Left (CJ3)
Fig 4: Identifying I/P Components
GM1653129Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Headlamp Switch
2 Instrument Panel Cluster (IPC)
3 Inflatable Restraint Steering Wheel Module Coil
4 Driver Information Center (DIC) Switch
5 Ambient Light Sensor
6 Inflatable Restraint Passenger Air Bag On/Off Indicator (Sedan w/o 9C1, 9C3)
7 Radio
8 Inflatable Restraint I/P Module
9 I/P Trim Panel
10 Heated Seat Switch - Passenger (KA1)
11 HVAC Control Module
12 Heated Seat Switch - Driver (KA1)
13 Turn Signal/Multifunction Switch
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.