SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 805 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)REPAIR INSTRUCTIONSRADIO REPLACEMENT
2006 Pontiac G6 GTP, 2D Coupe, Standard

Radio Replacement

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Radio Replacement
WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Replacing Radio
GM1594542Courtesy of GENERAL MOTORS CORP.
Radio Replacement

Callout Component Name
NOTE: Refer to Fastener Notice
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications 

Preliminary Procedure

  1. Remove the instrument panel accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement (Impala) or Instrument Panel Accessory Trim Plate Replacement (Monte Carlo)
  2. Remove the heating and air conditioning control module. Refer to HVAC Control Assembly Replacement
  3. Slightly push the antenna lead toward the radio to relieve tension on the internal fingers. Pull back on the spring-loaded locking ring and remove the connector from the radio.
  4. To install the antenna lead, plug the antenna lead into the socket until it clicks.
  5. Program the radio after replacement. Refer to Control Module References
1 Radio Bolt/Screw (Qty: 4)

Tighten:  2 N.m (18 lb in)
2 AM/FM Stereo Radio
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.