Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 8 (COMPUTER/INTEGRATING SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL DATA LIST
2006 Pontiac G6 GTP, 2D Coupe, Standard
Scan Tool Data List
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Scan Tool Data List
WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
ABS/TCS
| Scan Tool Parameter | Units Displayed | Typical Data Value |
|---|---|---|
| Operating Conditions: Ignition in RUN Position, Engine OFF, All Doors Closed, Park Brake Applied (DRLs OFF) | ||
| ABS Fault | Yes/No | No |
| Battery 1 | Volts | Varies |
| Coolant Gauge Position | % of Gauge | Varies |
| Displayed Odometer | km/miles | Varies |
| Fuel Gauge Position | % of Full | Varies |
| Park Brake Switch | On/Off | On |
| Traction Active | Yes/No | No |
| Traction Control Status | On/Off | On |
| Traction LED Command | On/Off | On |
| Traction LED Feedback | High/Low | Low |
Switch Inputs
| Scan Tool Parameter | Units Displayed | Typical Data Value |
|---|---|---|
| Operating Conditions: Ignition in RUN Position, Engine OFF, All Doors Closed, Park Brake Applied (DRLs OFF) | ||
| A/C Request (RPO C60) | Yes/No | No |
| Battery 1 | Volts | Varies |
| Decklid Ajar Switch | High/Low | High |
| Driver Door Switch | High/Low | High |
| Front Wiper Delay Switch | On/Off | Off |
| High Beam Input=DRL | Yes/No | No |
| High Beam Input=High | Yes/No | No |
| High Beam Input=Off | Yes/No | Yes |
| Key In Ignition | Yes/No | Yes |
| Lock Switch | On/Off | Off |
| Low Beam Input = DRL (Late 2004) | Yes/No | No |
| Low Beam Input = High (Late 2004) | Yes/No | No |
| Low Beam Input = Off (Late 2004) | Yes/No | Yes |
| Low Beam Switch | On/Off | Off |
| Low Brake Fluid | Yes/No | No |
| Low Coolant | Yes/No | No |
| Oil Life Reset Switch | High/Low | High |
| Park Brake Switch | On/Off | On |
| Parklamp Switch | On/Off | Off |
| Pass Door Switches | High/Low | High |
| Rear Defog Relay Cmd. | On/Off | Off |
| Rear Defog Relay Fdbk. | High/Low | High |
| Rear Defog Switch (RPO C60) | On/Off | Off |
| Rear Wiper Switch | On/Off | Off |
| Shifter Unlock Cmd | On/Off | Off |
| Shifter Unlock Fdbk. | High/Low | High |
| Unlock Switch | On/Off | Off |
Exterior Lamps
| Scan Tool Parameter | Units Displayed | Typical Data Value |
|---|---|---|
| Operating Conditions: Ignition in RUN Position, Engine OFF, All Doors Closed, Park Brake Applied (DRLs OFF) | ||
| ALC Light Sensor | Volts | Varies |
| Battery 1 | Volts | Varies |
| DRL Relay Command | On/Off | Off |
| DRL Relay Feedback | High/Low | High |
| Headlamp Cmd. | On/Off | Off |
| Headlamp Fdbk. | High/Low | High |
| High Beam Input | Volts | Varies |
| High Beam Input=DRL | Yes/No | No |
| High Beam Input=High | Yes/No | No |
| High Beam Input=Off | Yes/No | Yes |
| Low Beam Input (Late 2004) | Volts | Varies |
| Low Beam Input = DRL (Late 2004) | Yes/No | No |
| Low Beam Input = High (Late 2004) | Yes/No | No |
| Low Beam Input = Off (Late 2004) | Yes/No | Yes |
| Low Beam Switch | On/Off | Off |
| Parklamp Cmd. | On/Off | Off |
| Parklamp Fdbk. | High/Low | High |
| Parklamp Input | Volts | Varies |
| Parklamp Switch | On/Off | Off |
Interior Lamps
| Scan Tool Parameter | Units Displayed | Typical Data Value |
|---|---|---|
| Operating Conditions: Ignition in RUN Position, Engine OFF, All Doors Closed, Park Brake Applied (DRLs OFF) | ||
| Battery 1 | Volts | Varies |
| Dome Lamp Command | On/Off | Off |
| Dome Lamp Feedback | High/Low | High |
| Driver Door Switch | High/Low | High |
| Key In Ignition | Yes/No | Yes |
| Inadvertent Power Cmd. | On/Off | On |
| Inadvertent Power Fdbk. | High/Low | High |
| I/P Dimmer Input | Volts | Varies |
| I/P Dimmer Output | % DC | Varies |
| Pass Door Switches | High/Low | High |
Door Locks
| Scan Tool Parameter | Units Displayed | Typical Data Value |
|---|---|---|
| Operating Conditions: Ignition in RUN Position, Engine OFF, All Doors Closed, Park Brake Applied (DRLs OFF) | ||
| Battery 1 | Volts | Varies |
| Driver Unlock Relay Cmd. | On/Off | Off |
| Driver Unlock Relay Fdbk. | High/Low | Low |
| Lock All Relay Cmd. | On/Off | Off |
| Lock All Relay Fdbk. | High/Low | Low |
| Lock Switch | On/Off | Off |
| Remote Lock Command | Yes/No | No |
| Remote Panic Command | Yes/No | No |
| Remote Trunk Command | Yes/No | No |
| Remote Unlock Command | Yes/No | No |
| Pass Unlock Relay Cmd. | On/Off | Off |
| Pass Unlock Relay Fdbk. | High/Low | Low |
| Trunk Release Sol. Cmd. | On/ Off | Off |
| Trunk Release Sol. Fdbk. | High/Low | Low |
| Trunk Release Switch | On/Off | Off |
| Unlock Switch | On/Off | Off |
Wiper/Washer
| Scan Tool Parameter | Units Displayed | Typical Data Value |
|---|---|---|
| Operating Conditions: Ignition in RUN Position, Engine OFF, All Doors Closed, Park Brake Applied (DRLs OFF) | ||
| Battery 1 | Volts | Varies |
| Front Washer Motor Input | On/Off | Off |
| Front Wiper Delay Relay Cmd. | On/Off | Off |
| Front Wiper Delay Relay Fdbk. | High/Low | High |
| Front Wiper Delay Switch | On/Off | Off |
| Rear Washer Motor Input | On/Off | Off |
| Rear Wiper Relay Cmd. | On/Off | Off |
| Rear Wiper Relay Fdbk. | High/Low | Low |
| Rear Wiper Switch | On/Off | Off |
| Washer Fluid Level | Low/OK | Ok |
| Wiper Delay Input | Volts | Varies |
| Wiper Delay 1 | Yes/No | Varies |
| Wiper Delay 2 | Yes/No | Varies |
| Wiper Delay 3 | Yes/No | Varies |
Security Data
| Scan Tool Parameter | Units Displayed | Typical Data Value |
|---|---|---|
| Operating Conditions: Ignition in RUN Position, Engine OFF, All Doors Closed, Park Brake Applied (DRLs OFF) | ||
| Accessory | High/Low | High |
| Auto-Learn Timer | Seconds | Varies |
| Battery 1 | Volts | Varies |
| Decklid Ajar Switch | High/Low | High |
| Horn Relay Command | On/Off | Off |
| Horn Relay Feedback | High/Low | High |
| Ignition 1 Input | High/Low | High |
| Key Learned | No | Yes |
| Key Learn Enabled | Yes/No | Yes |
| Passlock Input | Volts | Varies |
| Passlock Power Fdbk. | High/Low | High |
| Passlock Timer | Seconds | Varies |
| Security LED | On/Off/Flash | Off |
| Trunk Release Switch | On/Off | Off |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.