SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 772 (THEFT DETERRENT SYSTEM)REPAIR INSTRUCTIONSTHEFT DETERRENT MODULE REPLACEMENT
2006 Pontiac G6 GTP, 2D Coupe, Standard

Theft Deterrent Module Replacement

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Theft Deterrent Module Replacement
WARNING: This page is about a different car, the 2007 Saturn Sky. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Theft Deterrent Control Module
GM1581909Courtesy of GENERAL MOTORS CORP.
Theft Deterrent Module Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  2. Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
1 Theft Deterrent Module Assembly
Tip: 
  1. Disconnect the electrical connector.
  2. Program the theft deterrent control module after replacement. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.