SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 74 (ENTERTAINMENT SYSTEMS)REPAIR INSTRUCTIONSRECEIVER REPLACEMENT - DIGITAL RADIOINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Digital Radio Receiver & Receiver Bracket
    GM1203642Courtesy of GENERAL MOTORS CORP.
  1. Connect the antenna connector.
  2. Connect the electrical connector.
  3. Install the electrical connector CPA.
  4. Install the digital radio receiver to the receiver bracket.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the digital radio receiver nuts.

    Tighten:  Tighten the nuts to 5 N.m (44 lb in).

    6. Fig 2: View Of Rear Compartment Trim Panel & Receiver Bracket
    GM907783Courtesy of GENERAL MOTORS CORP.
  6. Align the receiver and bracket assembly to the studs.
  7. Install the receiver bracket nuts.

    Tighten:  Tighten the nuts to 4 N.m (35 lb in).

  8. Install the left rear compartment trim panel. Refer to Compartment Trim Panel Replacement - Rear in Body Rear End.
  9. Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.