SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 697 (SECONDARY AND CONFIGURABLE CUSTOMER CONTROLS)REPAIR INSTRUCTIONSSTEERING WHEEL CONTROL SWITCH ASSEMBLY REPLACEMENT (SS)
2006 Pontiac G6 GTP, 2D Coupe, Standard

Steering Wheel Control Switch Assembly Replacement (SS)

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Steering Wheel Control Switch Assembly Replacement (SS)
WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Steering Wheel Control Switch
GM1791973Courtesy of GENERAL MOTORS CORP.
Steering Wheel Control Switch Assembly Replacement (SS)

Callout Component Name
CAUTION: Refer to SIR Caution .
Preliminary Procedure: Remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement (Non-SS) or Inflatable Restraint Steering Wheel Module Replacement (SS) .
1 Steering Wheel Trim Cover Bolt (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  2 N.m (18 lb in)
2 Steering Wheel Trim Cover (Qty: 2)
3 Steering Wheel Control Switch Assembly (Qty: 2)
Tip: 
  • Disconnect the electrical connectors.
  • Make sure the steering wheel control switches are properly seated to the steering wheel trim cover during installation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.