SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 697 (SECONDARY AND CONFIGURABLE CUSTOMER CONTROLS)COMPONENT LOCATORSECONDARY/CONFIGURABLE CONTROL CONNECTORSSTEERING WHEEL CONTROLS - LEFT (4-SPOKE) CONNECTOR
2006 Pontiac G6 GTP, 2D Coupe, Standard

Steering Wheel Controls - Left (4-Spoke) Connector

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Steering Wheel Controls - Left (4-Spoke) Connector
WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Steering Wheel Controls - Left (4-Spoke) Connector End View
GM1711015Courtesy of GENERAL MOTORS CORP.
Steering Wheel Controls - Left (4-Spoke) Connector Parts Information

Connector Part Information 
  • OEM: 30700-1100
  • Service: See Catalog
  • Description: 10-Way F HDAC64 DR Series (GY)
Terminal Part Information 
  • Terminal/Tray: See Terminal Repair Kit
  • Core/Insulation Crimp: See Terminal Repair Kit
  • Release Tool/Test Probe: See Terminal Repair Kit
Steering Wheel Controls - Left (4-Spoke) Connector Terminal Identification

Pin Wire Color Circuit No. Function
1 PK 339 Ignition 1 Voltage
2 - - Not Used
3 GY 1884 Cruise Control Switch Signal
4 - - Not Used
5 L-GN 696 Cruise Control Cancel Signal
6 GY 8 Instrument Panel Lamp Supply Voltage
7 - - Not Used
8 BK/WH 651 Ground
9-10 - - Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.