SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 674 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWIPER DRIVE SYSTEM MODULE REPLACEMENTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Wiper Motor Assembly
    GM1206780Courtesy of GENERAL MOTORS CORP.
  1. Install the wiper motor. Refer to Wiper Motor Replacement .
    2. Fig 2: View Of Electrical Connector And Wiper Motor
    GM1326390Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connector to the wiper motor.
  3. Connect the clip retaining the electrical harness to the wiper module.
    4. Fig 3: View Of Wiper Drive System Module
    GM1201895Courtesy of GENERAL MOTORS CORP.
  4. Position the wiper module assembly into the plenum.
    5. NOTE: Refer to Fastener Notice .
  5. Install the fasteners attaching the wiper module assembly to the plenum.

    Tighten:  Tighten the fasteners to 10 N.m (89 lb in).

  6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  7. Install the wiper arms. Refer to Wiper Arm Replacement .
  8. Inspect the washers for proper operation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.