SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 670 (ADJUSTABLE PEDAL SYSTEM)COMPONENT LOCATORADJUSTABLE PEDAL CONNECTORSADJUSTABLE PEDAL MODULE CONNECTOR
2006 Pontiac G6 GTP, 2D Coupe, Standard

Adjustable Pedal Module Connector

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Adjustable Pedal Module Connector
WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Adjustable Pedal Module Connector End View
GM39746Courtesy of GENERAL MOTORS CORP.
Adjustable Pedal Module Connector Parts Information

Connector Part Information 
  • OEM: 12064862
  • Service: 12126438
  • Description: 8-Way F Metri-Pack 150 Series (BK)
Terminal Part Information 
  • Pins: A-B, D, F-H
  • Terminal/Tray: 12064971/5
  • Core/Insulation Crimp: E/C
  • Release Tool/Test Probe: 12094429/J-35616-2A (GY)
  • Pins: E
  • Terminal/Tray: 12047767/2
  • Core/Insulation Crimp: E/A
  • Release Tool/Test Probe: 12094429/J-35616-2A (GY)
Adjustable Pedal Module Connector Terminal Identification

Pin Wire Color Circuit No. Function
A L-BU 5499 Adjustable Pedal Enable Signal
B PK 5289 Adjustable Pedals Position Sensor Signal
C - - Not Used
D BN/WH 5288 Adjustable Pedals Position Sensor Low Reference
E BK/WH 651 Ground
F WH 5287 Adjustable Pedals Position Sensor 5-Volt Reference
G L-GN 5980 Adjustable Pedal Inhibit Signal
H RD/WH 740 Battery Positive Voltage
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.