Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 663 (MIRROR SYSTEM)REPAIR INSTRUCTIONSMIRROR FACE REPLACEMENTREMOVAL PROCEDURE

2006 Pontiac G6 GTP, 2D Coupe, Standard

Removal Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Removal Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Refer to EYE PROTECTION CAUTION .

Carefully push the outside rearview mirror face on the inner edge (near the front door window glass) to allow finger access.

Fig 1: View Of Glass Mirror Face

Courtesy of GENERAL MOTORS CORP.

Grasp the mirror face firmly and pull it from the mirror body.
Remove the outside rearview mirror case from the outside rearview mirror housing and disconnect the heater wire (if equipped).

Fig 2: Identifying Mirror Case Jackscrews

Courtesy of GENERAL MOTORS CORP.

Remove the 2 jackscrews from back of the mirror case.
- Bend the 2 jackscrews over.
- Press down on the side of the jackscrew popping the screw from the mirror glass case.
- Save the jackscrews for reinstallation to the mirror motor.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.