Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 654 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSSTARTER MOTOR REPLACEMENT (LZ9)INSTALLATION PROCEDURE

2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Starter Motor & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the starter motor.

NOTE: Refer to Fastener Notice .

Install the starter motor bolts.
Tighten: Tighten the bolts to 43 N.m(32 lb ft).

Fig 2: View Of Battery Positive Cable & Solenoid

Courtesy of GENERAL MOTORS CORP.

Install the engine wiring harness (2) terminal and the positive battery cable (1) to the starter solenoid.
Install the positive battery cable nut (3) to the starter solenoid.
Tighten: Tighten the nut to 10 N.m(89 lb in).

Fig 3: View Of Negative Battery Cable

Courtesy of GENERAL MOTORS CORP.

Connect the engine wiring harness electrical connector to the starter motor.

Fig 4: Torque Converter Cover

Courtesy of GENERAL MOTORS CORP.

Install the torque converter cover (2).
Install the torque converter cover bolt (1).
Tighten: Tighten the bolt to 10 N.m(89 lb in).
Lower the vehicle.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.