SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 654 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSGENERATOR REPLACEMENT (LZ4)REMOVAL PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Removal Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Removal Procedure
WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Wiring Harness Electrical Connector
    GM1777669Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the drive belt. Refer to Drive Belt Replacement .
  3. Disconnect the engine wiring harness electrical connector (3).
  4. Reposition the engine wiring harness terminal boot (4).
  5. Remove the engine wiring harness terminal lead to generator nut (1).
  6. Remove the engine wiring harness terminal (2) from the generator stud.
    7. Fig 2: View Of Power Steering Pump
    GM1777755Courtesy of GENERAL MOTORS CORP.
  7. Remove the power steering line clip nut (1).
  8. Remove the power steering line clip (2) from the generator stud and reposition the lines out of the way.
    9. Fig 3: View Of Generator Rear Brace Upper Nut
    GM1775001Courtesy of GENERAL MOTORS CORP.
  9. Remove the generator through bolt (3).
    10. Fig 4: Generator
    GM1784880Courtesy of GENERAL MOTORS CORP.
  10. Remove the generator side bolt and stud.
  11. Remove the generator.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.