Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 604 (SHIFT INTERLOCK SYSTEM)COMPONENT LOCATORSHIFT LOCK CONTROL COMPONENT VIEWS
2006 Pontiac G6 GTP, 2D Coupe, Standard
Shift Lock Control Component Views
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Shift Lock Control Component Views
WARNING: This page is about a different car, the 2006 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Steering Wheel Control Switch - Left |
| 2 | Horn Switches |
| 3 | Steering Wheel Control Switch - Right |
| 4 | Horn Switches |
| 5 | Ignition Switch |
| 6 | Theft Deterrent Module (TDM) |
| 7 | Ignition Lock Cylinder Solenoid (A51) |
| 8 | Steering Angle Sensor (JL4) |
| 9 | Inflatable Restraint Steering Wheel Module Coil |
| 10 | Turn Signal/Multifunction Switch |
| Callout | Component Name |
|---|---|
| 1 | A/T Shift Lock Control Solenoid (AN3) |
| 2 | Reverse Lockout Solenoid C1 (A51) |
| 3 | Reverse Lockout Solenoid (A51) |
| 4 | Reverse Lockout Solenoid C2 (A51) |
| 5 | Shifter Background Lamp |
| 6 | Auxiliary Power Outlet (A51) |
| 7 | Traction Control Switch |
| 8 | Cigar Lighter (DT4 w/A51)/Auxiliary Power Outlet (A51) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.