Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 600 (POWER ROOF SYSTEM)REPAIR INSTRUCTIONSSUNROOF MOTOR/ACTUATOR INITIALIZATION/TEACH PROCESSINITIALIZATION/TEACH PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard
Initialization/Teach Procedure
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Initialization/Teach Procedure
WARNING: This page is about a different car, the 2006 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure that all electrical harness connectors are connected.
- Turn the ignition to ON.
- Press and hold the sunroof switch to the vent open position until the sunroof window stops, then release the switch.
- Press and hold the sunroof switch in the vent open position. The window should stall at the hard stop, then lower slightly to the soft stop position. Continue holding the switch for at least 5 seconds, then release the switch.
- If the window did stall at the vent open hard stop and lower slightly, go to step 6. If the window did not stall at the vent open hard stop and lower slightly, repeat step 4.
- Verify the operation of the sunroof in all positions.
IMPORTANT:
The initialization/teach procedure is not complete if the battery and/or ignition power has been interrupted during the process.
The Initialization/Teach Process must be restarted if the procedure is not carried out completely.
The Initialization/Teach Process must be restarted if the procedure is not carried out completely.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.