Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Scan Tool Data List
The scan tool data list contains all the object detection system related parameters that are available on the scan tool. The parameters in the list are arranged in alphabetical order. The column, Data List, indicates the location of the parameter within the scan tool menu selections.
Use the object detection scan tool data list as directed by a diagnostic table or in order to supplement the diagnostic procedures. Begin all of the diagnostic procedures with the Diagnostic System Check - Vehicle. Use the scan tool data list after the following is determined:
- There is no published diagnostic trouble code (DTC) procedure nor published symptom procedure for the customer concern.
- The DTC or symptom diagnostic procedure indicated by the diagnostic system check does not resolve the customer concern.
The typical data values are obtained from a properly operating vehicle under the conditions specified in the second row of the scan tool data list table. Comparison of the parameter values from the suspect vehicle with the typical data values may reveal the source of the customer concern.
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Ignition ON/Engine OFF/Object Detection Enabled | |||
| Battery Voltage Signal | Battery Data | Volts | 0-19 V (Varies w/battery voltage) |
| Loudspeaker Feed Voltage Output | Battery Data | Volts/Counts | Varies |
| Park Assist Disable History (1-8) | History Data | Empty/Manual Disable/Park Brake/Hitch Object Attached/Reverse Overspeed/Inhibit/Sensor Disturbance/Snow,Ice,Mud/Sensor Ring Time | Empty |
| Park Assist Front Display LED CKT | Battery Data | Ok/Over Current | Ok |
| Park Assist Front Y1 LED | System Data | Off/On | Off |
| Park Assist Front Y2 LED | System Data | Off/On | Off |
| Park Assist Front Red LED | System Data | Off/On | Off |
| Park Assist Switch | System Data | Active/Inactive | Active |
| Park Assist Switch LED | System Data | Off/On | Off |
| Park Assist Switch LED CKT | Battery Data | Ok/Over Current | Ok |
| Park Assist Rear Display LED CKT | Battery Data | Ok/Over Current | Ok |
| Park Assist Rear Y1 LED | System Data | Off/On | Off |
| Park Assist Rear Y2 LED | System Data | Off/On | Off |
| Park Assist Rear Red LED | System Data | Off/On | Off |
| Park Assist System Status | System Data | Enable/Disable/Inhibit/Failed/Blocked | Enable |
| Power Mode | System Data | Off/Accessory/Run/Crank Request | Run |
| Rear Region 1/2/3/4 | Alarm Data | No Detect/Zone 1/Zone 2/Zone 3/Zone 4/Zone 5/Zone 6/Zone 7/Zone 8 | No Detect |
| Sensor Feed Voltage Output | Battery Data | Volts/Counts | Varies |
| Vehicle Speed | System Data | mph (km/h) | 0 mph (0 km/h) |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.