SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 571 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING PUMP REPLACEMENT (L26)INSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2006 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Power Steering Pump Mounting Bolts
    GM464479Courtesy of GENERAL MOTORS CORP.
  1. Install the power steering pump to the engine.
    2. NOTE: Refer to Fastener Notice .
  2. Install the power steering pump retaining bolts.

    Tighten:  Tighten the power steering pump retaining bolts to 25 N.m (18 lb ft).

  3. Install the coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement .
  4. Raise the vehicle.
  5. Connect the wiring harness to the power steering pump.
    6. Fig 2: Identifying Power Steering Return Hose
    GM1740182Courtesy of GENERAL MOTORS CORP.
  6. Compress the clamp and connect the power steering return hose to the power steering pump.
    7. Fig 3: Identifying Steering Pump Flow Control Valve
    GM1739689Courtesy of GENERAL MOTORS CORP.
  7. Position the power steering pressure hose (3) to the power steering pump with the 2 NEW washers (2) and install the banjo bolt (1).

    Tighten:  Tighten the power steering pressure hose banjo bolt to 55 N.m (41 lb ft).

  8. Lower the vehicle.
  9. Install the drive belt. Refer to Drive Belt Replacement .
  10. Bleed the power steering system. Refer to Power Steering System Bleeding .
  11. Inspect the power steering system for leaks.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.