Power Mirror Switch Replacement

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Power Mirror Switch Replacement
WARNING: This page is about a different car, the 2006 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Power Mirror Switch
GM1646246Courtesy of GENERAL MOTORS CORP.
Power Mirror Switch Replacement

Callout Component Name
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:Β  Refer to Fastener Tightening Specifications .Preliminary Procedure:Β Remove the door trim panel. Refer to Front Side Door Trim Panel ReplacementΒ .
1 Front Side Door Switch Assembly
Tip:Β 
  1. The power window, door lock and power mirror switch are included in the one switch.
  2. Disconnect the electrical connectors.
  3. To disengage the switch assembly, push up on the switch assembly from the rear inside of the door trim panel.
2 Front Side Door Switch Screw (Qty: 3)

Tighten:Β  2 N.m (18 lb in)

3 Front Side Door Switch Plate
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.