Scan Tool Data List

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Scan Tool Data List
WARNING: This page is about a different car, the 2006 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
Scan Tool Data List

Scan Tool Parameter Data List Units Displayed Typical Data Value
Operating Conditions: Ignition ON, Engine OFF
Cooling Fan After Run Engine Data 2, Engine Data 3 Not Requested/Requested Not Requested
ECT Engine Data 1, Engine Data 2, Cooling/HVAC Data, EVAP Data, Fuel Trim Data Β°C/Β°F Varies
FC Relay 1 Command Engine Data 2, Cooling/HVAC Data On/Off Varies
FC Relay 2 and 3 Command Engine Data 2, Cooling/HVAC Data On/Off Varies
Low Coolant Status HVAC System Data OK/Low OK
Low Coolant Switch HVAC System Data Open/Closed Open
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.