Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 549 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSHEADLAMP REPLACEMENT

2006 Pontiac G6 GTP, 2D Coupe, Standard

Headlamp Replacement

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Headlamp Replacement

WARNING: This page is about a different car, the 2006 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Headlamp

Courtesy of GENERAL MOTORS CORP.

Headlamp Replacement

Callout	Component Name
Preliminary Procedure: Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement .
1	Headlamp Capsule Assembly Bolts (Qty: 3) NOTE: Refer to Fastener Notice . Tip: Tighten the fasteners in sequence as shown. Tighten: 6 N.m (53 lb in)
2	Headlamp Capsule Assembly Nut Tip: Access the nut by pulling back the front fender liner. Tighten: 6 N.m (53 lb in)
3	Headlamp Capsule Assembly Tip: The headlamp is engaged to the sheet metal by a stud located at the lower outboard corner and 2 pins in the center lower, inside the lamp. Pull the lamp outward to release the retainer pins from the body panel. Disconnect the electrical harness connector at the lower rear edge of the lamp.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.