SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 535 (ENGINE EXHAUST SYSTEM)REPAIR INSTRUCTIONSEXHAUST HEAT SHIELD REPLACEMENTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2006 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Positioning Shield Onto The Vehicle
    GM927081Courtesy of GENERAL MOTORS CORP.
  1. Position the shield to the vehicle, aligning the front hole stud. Place the rear of the shield under the rear shield and against the underbody.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nut and tighten.

    Tighten:  Tighten the heat shield-to-underbody nut to 10 N.m (89 lb ft).

  3. Install the rivets.
    4. Fig 2: View Of Hanger From The Rubber Isolators
    GM926825Courtesy of GENERAL MOTORS CORP.
  4. Install the manifold exhaust pipe. Refer to Exhaust Manifold Pipe Replacement (L66)  or Exhaust Manifold Pipe Replacement (L61) .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.