SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 49 (SHIFT INTERLOCK SYSTEM)REPAIR INSTRUCTIONSSHIFT LOCK CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Removal Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Removal Procedure
WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Shift Control Cable From Control Assembly
    GM893834Courtesy of GENERAL MOTORS CORP.
  1. Disable the SIR System. Refer to SIR Disabling and Enabling Zones in SIR.
  2. Remove the console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
  3. Using a screwdriver, disconnect the control cable end from the pin on the control assembly.
  4. Remove the control cable retaining clip.
  5. Press the tabs on the control cable and remove the cable from the control assembly.
    6. Fig 2: Removing/Installing Shift Lock Control Assembly Electrical Connectors
    GM893835Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the control assembly electrical connectors.
    7. Fig 3: Removing/Installing Shift Control Assembly
    GM893837Courtesy of GENERAL MOTORS CORP.
  7. Remove the control assembly-to-floor pan bolts and remove the control assembly.
  8. If the shifter control assembly is being replaced, transfer the parts as needed. Refer to the appropriate procedures in this service information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.