Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 486 (PROGRAMMING AND SETUP - ALL SYSTEMS)REPAIR INSTRUCTIONSENGINE CONTROL MODULE PROGRAMMING AND SETUPECM REPLACEMENT
2006 Pontiac G6 GTP, 2D Coupe, Standard
ECM Replacement
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION ECM Replacement
WARNING: This page is about a different car, the 2006 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
If the engine control module (ECM) is replaced, the following procedures must be performed:
- ECM Reprogramming-Refer to Service Programming System (SPS) .
- Crankshaft Position (CKP) Variation Learn-Refer to CKP System Variation Learn Procedure in Engine Controls.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.