SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 441 (SEAT SYSTEM)REPAIR INSTRUCTIONSREMOTE CONTROL REPLACEMENT - SIT-N-LIFTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Remote Control
    GM1368565Courtesy of GENERAL MOTORS CORP.
  1. Install the remote control and the chord to the seat base.
    2. Fig 2: Locating Electrical Connector
    GM1368543Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connector to the seat base.
    3. Fig 3: View Of Right Side Upper Trim Panel
    GM1368170Courtesy of GENERAL MOTORS CORP.
  3. Install the rear trim panel to the seat base.
  4. Install the right side upper trim panel to the seat base.
  5. Test the seat for proper operation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.