SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 439 (HVAC SYSTEMS - MANUAL)REPAIR INSTRUCTIONSHVAC CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying HVAC Control Module
    GM1547652Courtesy of GENERAL MOTORS CORP.
  1. Connect the HVAC control module electrical connectors.
  2. Install the HVAC control module into the I/P opening.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the HVAC control module bolts/screws.

    Tighten:  Tighten the bolts/screws to 2.5 N.m (22 lb in).

  4. Install the I/P accessory trim plate. Refer to Accessory Trim Plate, Driver Information Display Switch Replacement - Instrument Panel in Instrument Panel, Gages and Console.
  5. Re-calibrate the actuators. Refer to Re-Calibrating Actuators .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.