SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 424 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING PUMP REPLACEMENTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the reservoir to the pump. Refer to Power Steering Reservoir Replacement - Off Vehicle (CB Series) .
  2. Install the power steering pump pulley. Refer to Power Steering Pulley Replacement .
    3. Fig 1: Locating Power Steering Pump Mounting Bolts
    GM281721Courtesy of GENERAL MOTORS CORP.
  3. Install the pump to the vehicle.
    4. NOTE: Refer to Fastener Notice .
  4. Install the power steering pump bolts.

    Tighten:  Tighten the bolts to 34 N.m (25 lb ft).

    5. Fig 2: Identifying Power Steering Return Hose From Power Steering Pump
    GM417981Courtesy of GENERAL MOTORS CORP.
  5. Connect the power steering return hose to the pump.
    6. Fig 3: View Of Power Steering Pressure Hose From Power Steering Pump
    GM417974Courtesy of GENERAL MOTORS CORP.
  6. Connect the power steering pressure hose to the pump.

    Tighten:  Tighten the fitting to 27 N.m (20 lb ft).

  7. Install the engine electrical harness to the reservoir retainers.
  8. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement for the 3.5L engine or Intake Manifold Cover Replacement for the 3.9L engine.
  9. Install the accessory drive belt to the power steering pump pulley. Refer to Drive Belt Replacement for the 3.5L engine or Drive Belt Replacement for the 3.9L engine.
  10. Bleed the power steering system. Refer to Bleeding the Power Steering System .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.