SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 424 (POWER STEERING SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESPOWER STEERING SYSTEM TEST PROCEDURETEST DESCRIPTION
2006 Pontiac G6 GTP, 2D Coupe, Standard

Test Description

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Test Description
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 3:  This step tests the system for restrictions.
  2. 5:  This step tests the following components for the following conditions:
    • The pump for internal leaks
    • The power steering pipes for kinks
  3. 6:  This step tests the ability of the pump to regulate flow at maximum pressure.
  4. 8:  This step tests the ability of the pump to regulate flow under normal operating conditions.
  5. 10:  This step tests the internal components of the pump and the gear.
Power Steering System Test Procedure

Step Action Value(s) Yes No
NOTE: If the power steering system has been serviced, an accurate fluid level reading cannot be obtained unless air is bled from the steering system. The air in the fluid may cause pump cavitation noise and may cause pump damage over a period of time.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.