SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 415 (ENGINE COOLING SYSTEM)COMPONENT LOCATORCOOLING SYSTEM CONNECTORSMULTIFUNCTION SWITCH - OVERHEAD CONSOLE C2 (A20)
2006 Pontiac G6 GTP, 2D Coupe, Standard

Multifunction Switch - Overhead Console C2 (A20)

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Multifunction Switch - Overhead Console C2 (A20)
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Multifunction Switch - Overhead Console C2 (A20) Connector End View
GM73235Courtesy of GENERAL MOTORS CORP.
Cooling System Connector End Views

Connector Part Information 
  • OEM: 12047976
  • Service: 12102480
  • Description: 8-Way F Metri-Pack 280 Series (BU)
Terminal Part Information 
  • Terminal: 12034046/Tray 2
  • Core/Insulation Crimp: E/A
  • Release Tool/Test Probe: 12094430/J-35616-4A
Multifunction Switch - Overhead Console C2 (A20)

Pin Wire Color Circuit No. Function
A GY 8 Instrument Panel Lamp Supply Voltage
B BK 750 Ground
C TN 1018 Power Window Motor Rear Vents Open Control
D BN 1019 Power Window Motor Rear Vents Close Control
E YE 643 Accessory Voltage
F GY 2616 Rear Parking Assist Disable Switch Signal
G-H - - Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.