SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 403 (ENGINE CONTROLS - 3.5L - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSMANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REPLACEMENTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying MAP Sensor Retaining Bolt & Bracket
    GM1544765Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP sensor (1) to the intake manifold.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the MAP sensor retaining bracket (2) and bolt (3).

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 2: Disconnecting/Reconnecting Manifold Absolute Pressure (MAP) Sensor Electrical Connector
    GM1544767Courtesy of GENERAL MOTORS CORP.
  3. Connect the MAP sensor electrical connector (2).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.