Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 398 (CRUISE CONTROL SYSTEM)REPAIR INSTRUCTIONSCRUISE CONTROL SWITCH REPLACEMENTINSTALLATION PROCEDURE

2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Steering Wheel Components

Courtesy of GENERAL MOTORS CORP.

Install the cruise control switch (1).
Install the steering wheel trim cover (3).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the cruise control switch screws (2).
Tighten: Tighten the screws to 6 N.m (53 lb in).
Install the steering wheel rear trim cover screws (4).
Tighten: Tighten the screws to 6 N.m (53 lb in).

Fig 2: Identifying Steering Wheel Electrical Harness Grounding Screw

Courtesy of GENERAL MOTORS CORP.

Install the steering wheel electrical harness grounding screw (1).
Tighten: Tighten the screw to 6 N.m (53 lb in).
Attach the electrical harness connector retainer clip (2) to the steering wheel trim cover.
Install the steering wheel to the vehicle. Refer to Steering Wheel Replacement in Steering Wheel and Column.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.