SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 398 (CRUISE CONTROL SYSTEM)DESCRIPTION AND OPERATIONCRUISE CONTROL DESCRIPTION AND OPERATION (3.9L)NOTES
2006 Pontiac G6 GTP, 2D Coupe, Standard

Cruise Control Description and Operation (3.9L): Notes

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Notes
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Cruise control is a speed control system that maintains a desired vehicle speed under normal driving conditions at speeds above 40 km/h (25 mph). Steep grades may cause variations in the selected vehicle speeds.

The following are the main components of the cruise control system:

  • The accelerator pedal
  • The brake pedal position (BPP) sensor
  • The body control module (BCM)
  • The CANCEL switch
  • The instrument panel cluster (IPC)
  • The ON/OFF switch
  • The engine control module (ECM)
  • The RES/+ switch
  • The SET/- switch
  • The throttle actuator control (TAC) module
  • The TAC motor
  • The vehicle speed sensor (VSS)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.