SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 386 (CELLULAR COMMUNICATION SYSTEMS)REPAIR INSTRUCTIONSONSTAR MICROPHONE REPLACEMENTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Overhead Console Components
    GM1530702Courtesy of GENERAL MOTORS CORP.
  1. Position the OnStar® microphone (3) to the opening in the OnStar® button assembly (4).
  2. Push the OnStar® microphone (3) into the opening in the OnStar® button assembly (4) until the fasteners engage securing the microphone to the button assembly.
  3. Connect the electrical connectors.
    4. Fig 2: View Of Overhead Console Mounting
    GM1530697Courtesy of GENERAL MOTORS CORP.
  4. Align the overhead console within the vehicle.
  5. Press up on the overhead console engaging the fasteners in order to secure the console to the vehicle.
    6. NOTE: Refer to Fastener Notice .
  6. Install the overhead console screw.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

  7. Install the courtesy lamp lens.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.