Console Replacement - Overhead

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Console Replacement - Overhead
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Overhead Console
GM1540074Courtesy of GENERAL MOTORS CORP.
Console Replacement - Overhead

Callout Component Name
NOTE: Refer to Fastener Notice in Cautions and Notices.
Fastener Tightening Specifications:Β  Refer to Fastener Tightening SpecificationsΒ .
1 Reading Lamp Lens
Tip:Β  Use a small flat bladed tool to release the lens from the roof console.
2 Reading Lamp Bulb (Qty: 2)
3 Roof Console Screw (Qty: 2)

Tighten:Β  2 N.m (18 lb in)

4 Roof Console Bezel Assembly
Tip:Β  Disconnect the electrical connectors.
5 Roof Console Screw (Qty: 2)

Tighten:Β  2 N.m (18 lb in)

6 Roof Console Bezel Retaining Clip (Qty: 2)
7 Sunroof Switch
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.