Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 229 (ENGINE CONTROLS - 2.2L (L61) INTRODUCTION)REPAIR INSTRUCTIONSMANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REPLACEMENTINSTALLATION PROCEDURE

2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Install the MAP sensor with port seal into the intake manifold.

Fig 1: View Of Manifold Absolute Pressure Sensor
Courtesy of GENERAL MOTORS CORP.
Connect the MAP sensor electrical connector. Push in the connector until a click is heard and pull back to confirm a positive engagement.
Install the outlet resonator/duct assembly into position.
Connect the PCV fresh air vent hose assembly.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Tighten the clamp at the throttle body assembly.
Tighten: Tighten the clamp to 4 N.m (36 lb. in.).
Position the outlet resonator/duct assembly up with the support bracket and install the push-pin.
Tighten the clamp at the air cleaner assembly.
Tighten: Tighten the clamp to 4 N.m (36 lb. in.).
Connect the IAT sensor connector.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.