Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 227 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REPAIR INSTRUCTIONSINFLATABLE RESTRAINT SIDE IMPACT SENSOR REPLACEMENTINSTALLATION PROCEDURE

2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Remove any dirt, grease, or other contaminants from the mounting surface.
Connect the SIS electrical connector and insert into the connector position assurance (CPA) to secure.

Fig 1: Locating SIS Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Place the SIS through the access hole in the lock pillar.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Slide the module down and locate the captured fastener in the key slots of the lock pillar.
Tighten: Tighten the fastener to 10 N.m (89 lb. in.).
Install the center pillar lower molding. Refer to Garnish Molding Replacement - Center Pillar Lower in Interior Trim.
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2 or to SIR Disabling and Enabling Zone 6 .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.