Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 227 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REPAIR INSTRUCTIONSINFLATABLE RESTRAINT SENSING AND DIAGNOSTIC MODULE REPLACEMENTREMOVAL PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard
Removal Procedure
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Removal Procedure
WARNING: This page is about a different car, the 2005 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Disable the SIR system. Refer to SIR Disabling and Enabling Zone 8 .
- Remove the console assembly. Refer to Console Replacement - Front Floor in Instrument Panel, Gages, and Console.
- Remove the retainers from the connector position assurance (CPA) and disconnect the electrical connectors.
- Remove the nuts and remove the sensing and diagnostic module (SDM).
CAUTION:
Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.