Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 198 (SHIFT INTERLOCK SYSTEM)REPAIR INSTRUCTIONSAUTOMATIC TRANSMISSION SHIFT LOCK ACTUATOR REPLACEMENTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard
Installation Procedure
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2005 Pontiac G6. However, it is still accessible from the selected car via links, so may be relevant.
- Route the shift lock control solenoid through the opening in the front of the control assembly.
- Attach the ball sockets to the control assembly body and the shift-lock control lever.
- Connect the electrical connector to the Shift Lock Control Solenoid.
- Install the automatic transaxle control assembly. Refer to Floor Shift Control Replacement .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.