SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 197 (SUNROOF SYSTEM)REPAIR INSTRUCTIONSSUNROOF MODULE ASSEMBLY REPLACEMENT (CF5)INSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2005 Pontiac G6. However, it is still accessible from the selected car via links, so may be relevant.
  1. If you are replacing the sunroof module assembly, install the sunroof motor/actuator. Refer to Sunroof Motor/Actuator Replacement (C3Y)  or Sunroof Motor/Actuator Replacement (CF5) .
    2. Fig 1: View Of Sunroof Module
    GM1222469Courtesy of GENERAL MOTORS CORP.
  2. With the aid of an assistant, position the sunroof module assembly to the roof ring.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the four bolts which secure the sunroof module assembly to the roof ring.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    4. Fig 2: View Of Bolts Securing Sunroof Module Motor Base To Roof
    GM1224092Courtesy of GENERAL MOTORS CORP.
  4. Using the access hole in the sunroof module cross bar, install the push-pin fastener which secures the rear sunroof water gutter to the roof.
  5. Install the 2 bolts which secure the sunroof motor base to the roof.

    Tighten:  Tighten the bolts to 2 N.m (18 lb in).

    6. Fig 3: View Of Sunroof Front Drain Hose
    GM893482Courtesy of GENERAL MOTORS CORP.
  6. Connect the front and rear drain hoses to the drain spigots.
  7. Install the sunshade. Refer to Sunroof Sunshade Panel Replacement (C3Y)  or Sunroof Sunshade Panel Replacement (CF5) .
    8. Fig 4: View Of Electrical Connector At Motor/Actuator
    GM1344700Courtesy of GENERAL MOTORS CORP.
  8. Raise and install the headliner. Perform the headliner replacement install steps 5 thru 24. Refer to Headliner Replacement in Interior Trim.

    Verify that the electrical connector is connected to the sunroof motor/actuator.

  9. Install the sunroof window. Adjust as necessary. Refer to Sunroof Window Replacement .
  10. Initialize the sunroof motor. Refer to Sunroof Motor/Actuator Initilization/Teach Process (Panoramic)  or Sunroof Motor/Actuator Initilization/Teach Process (New Motor)  or Sunroof Motor/Actuator Initilization/Teach Process (Existing Motor) .
  11. Install the sunroof finishing lace. Refer to Sunroof Finishing Lace Replacement (CF5)  or Sunroof Finishing Lace Replacement (C3Y) .
  12. Inspect the sunroof for proper operation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.