SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 197 (SUNROOF SYSTEM)REPAIR INSTRUCTIONSSUNROOF MODULE ASSEMBLY REPLACEMENT (C3Y)REMOVAL PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Removal Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Removal Procedure
WARNING: This page is about a different car, the 2005 Pontiac G6. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: A new sunroof module does not include the windows, motors, sunshade, or the finishing lace as components. Install the old components to the new sunroof module.
  1. Cycle the sunshade to the fully open position.
  2. Remove the front sunroof window. Refer to Sunroof Window Replacement - Front .
  3. Remove the 2nd or 3rd sunroof window. Refer to Sunroof Window Replacement - 2-3 .
  4. Remove the rear sunroof window. Refer to Sunroof Window Replacement - Rear .
  5. Remove the sunroof finishing lace. Refer to Sunroof Finishing Lace Replacement (CF5)  or Sunroof Finishing Lace Replacement (C3Y) .
  6. Cycle the sunshade to the fully closed position.
  7. Remove the headliner. Refer to Headliner Replacement in Interior Trim.
  8. Disconnect the electrical connectors from the motors.
  9. Disconnect the front and rear drain hoses from the drain spigots located in each corner.
    10. Fig 1: View Of Sunroof Module Rear Bolts
    GM1564607Courtesy of GENERAL MOTORS CORP.
  10. Remove the bolts (2) in the rear of the sunroof module first, then the bolts (1).

    The shade must be full closed position to expose the bolts (1).

    11. Fig 2: View Of Sunroof Module To Roof Ring Bolts
    GM1564610Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.