SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 176 (THEFT DETERRENT SYSTEM)REPAIR INSTRUCTIONSTHEFT DETERRENT CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2005 Pontiac G6. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Theft Deterrent Control Module
    GM1207719Courtesy of GENERAL MOTORS CORP.
  1. Install the theft deterrent control module.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Tighten the theft deterrent control module screws.

    Tighten:  Tighten the screws to 5 N.m (44 lb in).

  3. Install the ignition switch. Refer to Ignition Switch Replacement in Instrument Panel, Gages and Console.
  4. Perform the vehicle theft deterrent system learn procedure. Refer to Programming Theft Deterrent System Components .
  5. Program the theft deterrent control module after replacement. Refer to Control Module References in Computer/Integrating Systems.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.