Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 174 (KEYLESS ENTRY SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL OUTPUT CONTROLS
2006 Pontiac G6 GTP, 2D Coupe, Standard
Scan Tool Output Controls
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Scan Tool Output Controls
WARNING: This page is about a different car, the 2005 Pontiac G6. However, it is still accessible from the selected car via links, so may be relevant.
Scan Tool Output Controls
| Scan Tool Output Control | Additional Menu Selection(s) | Description |
|---|---|---|
| One Key Fob | Program Key Fobs | The remote control door lock receiver (RCDLR) programs one keyless entry transmitter for the keyless entry system. |
| Two Key Fobs | Program Key Fobs | The remote control door lock receiver (RCDLR) programs two keyless entry transmitters for the keyless entry system. |
| Three Key Fobs | Program Key Fobs | The remote control door lock receiver (RCDLR) programs three keyless entry transmitters for the keyless entry system. |
| Four Key Fobs | Program Key Fobs | The remote control door lock receiver (RCDLR) programs four keyless entry transmitters for the keyless entry system. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.